Peugeot 208 Key Replacement
Peugeot 208 key replacement is best left to auto locksmiths with experience who have the right equipment and technical knowledge. They can create and program new keys much quicker than a dealership and at a cheaper cost.
A dead battery for your coin is the most likely cause if your key fob stops locking or unlocking doors. However, there are many other reasons why the key might be malfunctioning.
Dead Coin Battery
A dead battery can stop your Peugeot 208 from locking and unlocking, as well as stopping it from starting the engine. In this scenario, you will need to make use of the alternative method for starting described in your vehicle owner's manual.
The spark plugs may also be worn out. Spark plugs are what ignite the fuel to start the engine. However they have a short life span. They will eventually break down if they're not used enough.
Luckily, there's an easy solution to this issue. Examine the voltage of your battery with a multimeter. If it's less than 11.5 Volts and you are not satisfied, then it is time to replace it. If the battery is damaged, it is important to clean its contacts. This can be done by removing the rubber covers from the two terminals on the battery and then using a wirebrush to clean any corroded battery parts. Then, reconnect the positive and negative pole cables.
Water Damage
If your 208 isn't starting and the battery is not running, then make sure that the spark plugs are functioning. You might find that they are simply too dirty and they don't spark. This can be easily corrected by cleaning the spark plugs in a workshop.
Peugeot cars use keys that are transponder-type and works with the car's ignition system. This makes sure that only the correct key is able to start the engine. If the chip inside the Peugeot key is damaged, then it will not send the proper signal to the vehicle.
Water damage is a typical reason for this issue. This is particularly common in colder climates where the vehicle could have been exposed to snow or rain. In this case, you need to contact a reliable locksmith who will have the required tools and equipment to modify the key. They will also have the most up-to-date technological know-how and the equipment required to make a Peugeot 208 smart key. The process shouldn't be more than 15 minutes.
Faulty battery contacts
Peugeot replaced the transponder chips using a new version that makes use of electronic components that are mounted on a circuit board. The new system is effective when it's new, however, over time, the circuit boards start to deteriorate and stop working correctly.
This could prevent the immobiliser from working, so the vehicle won't start. If this is the case it's a good idea to call a Peugeot specialist or locksmith.
Another common issue is when the battery of the key fob is dying, this causes the key blade to stop being able to feed into the lock. A locksmith for cars will replace the battery, and cut a new blade for you. This is a simple fix.
Faulty Receiver Module
If your Peugeot key fob isn't working after dropping it on the ground, being exposed to a sudden rain or accidentally washing it or washing it, it could be due to a malfunctioning receiver module. The receiver module is responsible for transmitting radio frequency to the onboard computer that regulates the central locking system of your Peugeot vehicle.
The key fob itself is fitted with rubber seals that block water from getting to the electronic chip inside. The chip can be damaged by water when exposed to the water for an extended period of time. The high salt content of the ocean or pool could cause damage to the key fob when it is submerged.
The module will need to be replaced if the Peugeot spare key isn't working anymore. This can only by done by a Peugeot specialist or a professional auto locksmith. Peugeot keys unlike other automobiles, are secured by an immobilizer device. This requires the right programming to allow the car to start. This is why you must go with a knowledgeable Peugeot locksmith to take on the job of creating and programming a replacement.
Computers with faulty on-board computers
The computer on board of your Peugeot is responsible for many of the features in your car, including airbags and power windows. If something is wrong with these systems, it will typically display a code indicating the issue. This code is stored inside the system and will stay there until the issue is solved. This may require the on-board computers to be replaced.
One of the most frequent reasons for the airbag light turning on is the loose or corroded connections within the airbag sensor. This can be caused by wear and tear, aging, or exposure to salt and moisture. This problem should be addressed as soon you can, since an airbag that is not functioning could be dangerous in the event of an accident.
If your Peugeot is showing a card that is not being detected error, then the battery in the key fob might be weak or dead. peugeot 207 car key g28carkeys.co.uk will stop the key fob sending a signal that will disable the immobilizer in your vehicle. Try this by pressing the unlock key on the fob's key and then trying to start your car. If this doesn't work it is likely that the battery must be replaced.